![]() Luckily the new barrel is really easy to unclog. I thought this was a really strange behavier, because the nozzle is hot enought to get the high flow part of the print done but not the low flow sections?!? However after a few more tries of raising the temperature and test-printing, this was my best result and in the end my nozzle got too hot, melted the filament right in top of the barrel and clogged. Another temperature rise later the printer finished printing the raft and then started skipping at the first bottom layer. Lower the bed at each point one at a time. As with the paper method, move the hotend carriage around to each of the corners and the center. Use the feeler gauge with the thickness of your layer height. But I’ve been pleased too early and right at the moment as the printer started with the thin raft lines, the extruder started skipping again. Go into the printer menu and move along the z-axis by the layer height you most commonly print with. I started a test print and while the nozzle was laying down some first fat raft lines, I was happy that my printer was back in business again. There is no silicone sock on this nozzle, maybe raising the temperature will help. The new nozzle arrived but at its first feed the extruder started skipping again while pushing out just a little bit of filament. It was my last nozzle so i decided to order the new V2 barrel and give that wear resistant nozzle a try. ![]() ![]() NEW: Support True-Touch Calibration probe, measure leveling and nozzle height values in a single process. I have already had pushed about 3 rolls through its tiny. NEW: V2 Hotend support hardened steel nozzles to print abrasive materials. Tries to clean it failed with the same result. One such tinkerer, Marco Reps, has been taking his new Cetus 3D printer to new places, and his latest video offers a trio of tips to enhance the user experience of this bare-bones but capable. Creatively Blend Colors Multi-Material 3D Printing New System New Future Powerful & User Friendly Fully Automatic Leveling and Z-Level Calibration Stable. At first i thought it was a clogged nozzle. It already has the V1 extruder installed.Ī few weeks ago my extruder started badly skipping steps while printing PLA. I own my Cetus MK2 for round about 3 years now. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |